On 6/9/22 8:53 PM, Bob kb8tq via time-nuts wrote:
Hi
There happen to be *some* AT cut based OCXO’s that beat the typical
SC cut on warmup … just saying …. :)
Bob
On the subject of rapid warm up. I suppose if you had a need, one could
dump as much power as you need into the heater. Turn on oscillator,
lights in room dim for a few moments.
But everything is a tradeoff, and I suspect that over time "standard
designs" sort of migrate to particular ratios of things like peak vs
average heater current, etc. Especially in applications driven by
design rules for things like "maximum current per connector pin" or
"component derating" - I suspect that drives things more than the
fundamental physics, in most cases. Why are diodes rated at 1 or 3
Amps? And not 2?
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe send an email to [email protected]
