On Sun, Aug 03, 2014 at 11:02:14PM -0600, Mark Lopez wrote: > I've recently moved from OpenVPN to Tinc for the mesh setup. Everything works > nicely except for some looping packet issues. > > I have 12 servers around the United States, including a couple of moving > clients. Every now and then the network is flooded with what I assume is > looping packets. 200-300MB of bandwidth per node over 10-45 minutes (normally > < 20 KB/s, idle). Most if not all nodes participate in the spike. Some nodes > just have a spike on output, some only on input. [...] > What causes this and is there a way to prevent these spikes? I estimate an > extra 4-5GB of extra bandwidth usage per node because of this.
Oh, that's quite a lot. First, which version of tinc are you using?
Which Mode (router or switch) are you using? Are you bridging the VPN
interface with the LAN interface on any of the nodes?
--
Met vriendelijke groet / with kind regards,
Guus Sliepen <[email protected]>
signature.asc
Description: Digital signature
_______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
