Hi, experts
I found the tun0 is 10Mb/s and I installed vnstat to monitor the tinc vpn
traffic statistic, but due to 10Mb/s, the vnstat couldn’t update it’s database
due to low speed rate, so anyway to change the tun from10Mb/s to higher?
[root@box1 ~]# vnstat -u
Info: Traffic rate for "myvpn" higher than set maximum 10 Mbit (248->341, r735
t38), syncing.
[root@box1 ~]# ethtool myvpn
Settings for myvpn:
Supported ports: [ ]
Supported link modes: Not reported
Supported pause frame use: No
Supports auto-negotiation: No
Advertised link modes: Not reported
Advertised pause frame use: No
Advertised auto-negotiation: No
Speed: 10Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
MDI-X: Unknown
Current message level: 0xffffffa1 (-95)
drv ifup tx_err tx_queued intr tx_done rx_status
pktdata hw wol 0xffff8000
Link detected: yes
_______________________________________________
tinc mailing list
[email protected]
https://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
