Hi everyone,
I have been bugged by the problem shown in the title.
I was following Section 5 "Test Applications and
Drivers for Sensor and Data Acquisition Boards" in the
"Getting Started Guide". The mote is micaz, the sensor
board is MDA300, and the programming board is MIB510.
I tried testing xlisten over an RF link. I configured
the two motes per the instruction, and set up the
connection:
-------- -------------
| MDA300 | | MICAz (base)|
-------- -------------
| MICAz | | MIB510 |
-------- --------------<------->com1 of PC
The first MICAz was programmed under /XSensorMDA300,
and the second one was programmed under /TOSBase with
node id 0. After I typed the xlisten command, there
was no output. But if I switched on and off the MICAz
radio attached to the MDA300, I saw the following
output. Unfortunately, the information received was in
error. It seemed to me that the RF link was OK,
because the serial port received some signal.
$ xlisten -r -p -c -b=micaz -s=com1
xlisten Ver:$Id: xlisten.c,v 1.2 2005/06/21 01:36:06
pipeng Exp $ Using params: [baud=0x1001] [raw]
[parsed] [cooked]
com1 input stream opened
7e42ffff007d5d1d81000100000000000000000000000000000000000000000000000000001
429 [39] mda300 error: unknown packet_id (0) MDA300
Error: unknown packet id (0)
7e42ffff007d5d1d81000100000000000000000000000000000000000000000000000000001
429 [39] mda300 error: unknown packet_id (0) MDA300
Error: unknown packet id (0)
I also tried using -b=57600, but the output was the
same.
Thanks in advance.
- Liangping
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
