There have been massive discussions of integrating sensors to the
mote serial port. Search back through the help list over the last
few months.
MS
Harri Siirtola wrote:
Hi Aung,
You can connect it into UART 1. The only drawback is, the tx/rx pins are
also used for external flash access and there's no built-in arbitration.
So you should take care of that if using your sensor and flash in the
same application.
Regards,
Harri
At 07:38 PM 3/3/2006 +0800, #AUNG AUNG PHYO WAI# wrote:
Content-class: urn:content-classes:message
Content-Type: multipart/alternative;
boundary="----_=_NextPart_001_01C63EB7.3D8C36DF"
Hi all,
I would like to ask all of you about questions related to integrating
new type of sensors into micaZ mote platform.
This new type of sensors provides a serial data output.
So is it possible to connect this sensor to micaZ mote for taking
data, pre-process and send to the PC for processing?
Currently, I checked the pin-outs of 51 pin connectors, I have no
ideas about which pin to connect from sensors. I also knew that some
of UART TX & RX pins are already used and could you please recommend
which pin is possible to use?
Thanks all of you in advance.
Regards,
Aung Aung Phyo Wai
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
