Can UART0 be used for the bsl?
Thanks,
Andrew
On 3/3/06, Andrew Redfern <[EMAIL PROTECTED]> wrote:
Hi Andrew,
I am looking to use the serial port to talk with another device. What I was thinking was that I could cut the UART1RX and UART1TX lines before they go to the I/O buffer and reroute them from the MSP430. The only problem is that I am not sure that the bsl does not send signals over these lines when the mote is reprogrammed.
AndrewOn 3/3/06, Andrew Jamieson < [EMAIL PROTECTED]> wrote:I would be interested to hear how you get on going down this route - I
am thinking of doing exactly the same thing to enable the use of a
peripheral device during normal operation, only using the USB for
reprogramming.
Andrew
Andrew Redfern wrote:
> If I very carefully reroute signals UART1RX and UART1TX to use as a
> serial port on the tmote. I should still be able to use the usb for
> reprogramming the mote right?
>
> Thanks,
> Andrew
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
--
Andrew Jamieson
Research Engineer
Institute for System Level Integration
Alba Centre, Alba Campus, Livingston, EH54 7EG
Tel: +44 1506 469 300 Fax: +44 1506 469 301
http://www.sli-institute.ac.uk/
_______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
