I'm not really sure what the problem you are seeing is caused from. A couple of questions: How are you powering the tmote? Where are you pulling the serial line from? (are you doing it right at the output of the MSP430 or on the other side of the IO buffer?)
Andrew
On 3/22/06, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote:
Hi, i programmed my TMote to send a byte on usb-serial port when a
Timer signal the "Fired Event".
Then i take the serial output BEFORE of
the FTDI chip, to interface my TMote with
another microcontroller
using RS232 protocol, but when i remove my TMote from Usb port, and i
connect it to my micro, it stop to send data on usb-serial port! so in
my microcontroller receive nothing.
I'm trying this way because using
the expansion serial port, it is shared with radio bus,
and i can lose
very important packets when the bus is assigned to expansion pins.
Alex
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
