You need to write a driver for your device. I'm pretty sure that your device doesn't understand TinyOS formatted packets that GenericComm sends. There's an article on Moteiv's support site about using UART0 with Boomerang:
http://www.moteiv.com/community/Boomerang_UART0_Sample -Joe On 3/23/06, Chris Morrison <[EMAIL PROTECTED]> wrote: > I've searched through the archives and can't find a definitive answer to > my question so I am hoping someone here can help. > > I'm looking to connect a display up to my mote through the serial ports > that are on the expansion pins and I have two problems, > 1. Can I use the genericComm to send to this UART or is it only the USB > port that can use the genericComm? > 2. If I can use the genericComm how do i change the baud rate from > 57600bps to 9600bps? How do i change the destination address so rather > than going through the USB port it goes through the UART (at the moment > i just use the line > > call Send.send( TOS_UART_ADDR,sizeof(IntMsg2),&data) > > to send to the UART but that sends over the USB instead of the expansion > UART. > > Thanks in advance, > > Chris > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > _______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
