RE: [Tinyos-help] Changing the frequency on Micaz motes

Tue, 11 Apr 2006 10:25:54 -0700

Locate the '...\apps\MakeXbowlocal' file.  Edit it.  Locate the section specific to the mote your using, i.e. MICAZ (it's towards the end of the file)  it will show you the exact frequencies for a specific channel.  Remove the '#' in front of the channel you wish to use.  Recompile, install on mote.  B.T.W. you can also change power level here (which is useful for testing mesh, etc. in a confined space).
 

S3C

David A. Howard

Staff Engineer

 

1010 Stewart Drive, Sunnyvale, CA 94085 USA

Tel: 408.746.3081  Fax: 408.746.9481  Cel: 510.303.0356

eMail: [EMAIL PROTECTED]   Skype: david_a_howard

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Gina Upperman
Sent: Tuesday, April 11, 2006 10:06 AM
To: [email protected]
Subject: [Tinyos-help] Changing the frequency on Micaz motes

We are trying to deploy a network of Crossbow Micaz motes and are worried about interference problems.  Does anyone know the exact frequency that these motes transmit at (ie, exactly 2.4 GHz)?  Is there any way of changing this frequency or the channel that they transmit on (Channels 1-16)?  Has anyone tried to use the:

 

app/ make xbow local

 

command to try to change the frequency?  Crossbow tech support was unhelpful - we were hoping someone might have experience with changing the frequencies, and we would appreciate any advice.

 

Thank you very much,

Gina Upperman

Rice University

 

 

 

_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help

Reply via email to