Hi Reizel,
for example the Cygwin command line syntax for MIB600 with micaz is:
$ make micaz reinstall,5 eprb,XXX.XXX.XXX.XXX
where the XXXs stand for the IP address you've set for your MIB600. If you
give this command, you can see the correct 'dprog' etc. switches. BTW, why
do you want to fiddle with Makerules for this?
Harri
At 02:33 AM 5/15/2006 -0700, reizel casaquite wrote:
Hi everyone,
I need help. I want to use MIB600 as a programming board.
Does anyone knows the proper syntax for the Programmer's flag?
The one below is I think for the MIB500 (parallel). How can I use MIB600?
PROGRAMMER_FLAGS=-dprog=dapa -dt_sck=1 $(PROGRAMMER_EXTRA_FLAGS)
Thanks for the help!
Regards,
reizel
How low will we go? Check out Yahoo! Messenger's low PC-to-Phone call rates.
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
