I am sorry I am still confused and lost. I wanted to run the S-PRIME protocol (TDMA MAC) using 6pcs MIB600 with mica2 motes on each. I was able to compile and upload the program in the motes though with some warnings. This may be due to the upgrades and modifications that were made.
Anyways, I wanted to compute the packet delivery ratio as what is written in the readme file by Lin Gu. I uploaded the Genericbase application in one of the motes but all I can see is that the red LED turned OFF. It says here that the Genericbase application captures all the packets that it can hear and report it back to the UART - forward all incoming UART messages out to the radio. I wonder how to compute the data delivery ratio then. :)
I am using MIB600 and the mote's serial port can be accessed via Tenet using Port#10002. Hence, I tried to use the serial forwarder using the command "java net.tinyos.sf.SerialForwarder -comm [EMAIL PROTECTED]:10002 (192.168.0.3 is the IP address of one MIB600 and my PC is 192.168.0.2 where all MIBs x.x.0.3 to x.x.0.8 are connected). I uploaded all the motes with Chirp.SPRIME however, there is no response nor packets read in the said serial forwarder. But when I uploaded an Oscilloscope app in that same mote (192.168.0.3), only the packets read increases.
I have also tried the MOTEVIEW by crossbow but still I failed. I am sorry I am really a beginner in TinyOS. I would like to ask how can I compute the data delivery rate of S-PRIME protocol using MIB600? Does anyone of you have tried the S-PRIME Protocol recently? How about using MIB600?
I think there is less documentation on how to use MIB600 on how to upload a code to a mote being attached on it.
Thank you very much!
P.S. @ Lin Gu: Thank you very much for your help. :D
Regards,
reizel
Lin Gu <[EMAIL PROTECTED]> wrote:
The screenshot you showed has only upload (uisp)
information. I do not know what the '#' marks
mean.
What I would do is to modify the GenericBase to
tally the packets received, as said in the README.
lin
On Thu, May 18, 2006 at 05:18:20AM -0700, reizel casaquite wrote:
> Hi,
>
> I uploaded the four motes with Chirp.SPRIME application and I am worried how to compute its success rate. Attached are the outputs using Genericbase and TOSbase on one mote only. As what you had said, I need to understand the S-PRIME implementation and the communication modules first since I am really new to this field. I hope it will be fun.
>
> Thank you for your patience and advice.
> Have a nice day!
>
> Regards,
> Reizel
>
>
> ---------------------------------
> Be a chatter box. Enjoy free PC-to-PC calls with Yahoo! Messenger with Voice.
--
Lin Gu
Department of Computer Science
University of Virginia
Tel: 434-825-3115
Web: http://www.cs.virginia.edu/~lg6e
--------------------------------------
Feel free to call! Free PC-to-PC calls. Low rates on PC-to-Phone. Get Yahoo! Messenger with Voice
How low will we go? Check out Yahoo! Messengers low PC-to-Phone call rates.
_______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
