You can connect the GIO pin to a transistor to switch the sensors power
supply on and off. Or you can connect the ground of the device to the
GIO pin, and sink the pin to turn it on. If you put the pin in high
impedance mode, the sensor will turn off (this is achieved by making the
GIO pin an input). Not sure how much current you can sink through the
pin though, however it should be a lot more than it will source.
Cheers,
Matt
Joe Polastre wrote:
ADC2 is output and low.
GIO pins can only source ~2mA of current, so I don't recommend using
them to power a device.
-Joe
On 9/3/06, Simon Davis <[EMAIL PROTECTED]> wrote:
Hello,
I'm trying to use GIO1 as a power source for a sensor so I can turn
it on and off to save power. If I put a voltmeter on the pad of R16 I
get the battery voltage of about 3V appearing as it turns on. If I
solder a 0ohm bridge on R16 to feed it to pin 7 of the 10 pin header
(which is also used by ADC2), the voltage drops to about 1.3V and it
draws over 30mA - this is without any load on pin 7.
What am I doing wrong!? It's presumably something programmatic. I'm
using TOSH_MAKE_GIO1_OUTPUT() and then turning it on and off with
TOSH_SET_GIO1_PIN() and TOSH_CLR_GIO1_PIN(). Should I do something
with ADC2 and why is the voltage dropping and 30mA being drawn?
Many thanks
Simon Davis
--
___________________________________________________
Play 100s of games for FREE! http://games.mail.com/
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
