|
Hi everybody
I ask you about I2C Pins of the MDA300. I should connect a sensor into my MicaZ network and I see we have I2C pins in the MDA300. In fact, I’ve a sensor that works as follow: 1) When an event is detected, the Enable output signal set up (edge). (here I should make an interrupt with my MDA300 Digital Pin D0) 2) After that, I should create a clock into the Clock pin of my sensor (Fmax=4Mhz) 3) In the rhythm of this clock, I read the data (32 bits) from the serial data output of my sensor. 4) At the end, a signal SDRY set up in high level during 100ns to inform the end of transactions.
So, can I use the I2C Clock and I2C Data pin in this case, with D0 and D1 for Enable & SDRY signals?
Or should I use 4 digital pins of my MDA300 and generate myself the Clock.
Someone have an application working with I2C interface?
Thanks for your Helps
Matt
|
_______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
