刘晓杰 ^-^ <happyaspen <at> sjtu.edu.cn> writes:
>
> hi,everyone
> I want to simulate Blink in Tinyviz ,so i compiled the Blink.nc to
main.exe.And then i run the command"
> tinyviz -run ./build/pc/main.exe 10 ". It did start tinyviz ,but it didn't
show any debug messages. And i
> notice that sim time is 0 sec.
> Can anyone give me some advice ,thanks a lot
>
> aspen
>
>
Hi, since you are also compliing Blink I guess you are also in the same state as
me. I'm a beginner, but I think we can help each other.
You have to chose the plugins from the menu on the upper left hand corner, of
all the radio links is the most helpful. Next click the button on the right hand
top to start the simulation (the start/pause button), you'll find a message at
the bottom of the window. The plugins that you select, corrosponding tabs get
selected by this and the related information is shown.
Hope this helps,
let me whats your project!
Tatha
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
