yes it requires baud rate to be specified and it should be 115200.
and u should not hear anything unless u r at 115200.

On 11/14/06, Phani Kumar Arava <[EMAIL PROTECTED]> wrote:
Does raw_listen.c use any baud rate ? . I thought it just dumps the serial port values ?

On 11/13/06, bandu khote < [EMAIL PROTECTED]> wrote:
Hi,

I am using raw_listen.c to read serial data from the tmote invent.
I can see the data but it appears to be garbled. As I change the baud rate,
when I select 38400, I see output which somewhat resembles the output
I am expecting.

Any pointers,  what is going wrong here.
Thanks
BK


Cheap Talk? Check out Yahoo! Messenger's low PC-to-Phone call rates.


_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help




--
Phani Kumar Arava
Grad Student                                             1560 Worthington Street
Department Of Computer Science                Columbus Ohio 43201
2015 Neil Avenue
Ohio State University
Columbus Ohio-43210

Contact: (614)-286-2618
URL : www.cse.ohio-state.edu/~arava/
mailto: [EMAIL PROTECTED],[EMAIL PROTECTED], [EMAIL PROTECTED]
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help




--
Sougata Sen
Bangalore
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help

Reply via email to