1. Make sure the slider switch on MIB510 (close to reset button) is OFF
2. Install mica mote _firmly_ to MIB510
3. Make sure you use the correct serial port in make command (/dev/ttyS0
is COM1)
4. Retry several times with make command (use "make mica reinstall,x to
avoid recompile), MIB510 isn't very reliable
Regards,
Harri
________________________________
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of ankur
jain
Sent: Wednesday, February 21, 2007 12:19 PM
To: tinyos-help
Subject: [Tinyos-help] Programming error on Mib-510
Hi all,
I am trying to program mica-2 mote using Mib-510 programming board using
IBM thinkpad. I have tried to install by both mechanisms (i.e through
Moteconfig as well as using make mica install.x utility from the
terminal). but in the first case it is giving following error:
"Programmer is not responding"
wheras in the second case it is giving:
"flash error at address xxx".repetedly for different addressse.
So please anybody could tell me where i am going wrong
and what should i do to rectify it..any kind of help would be highly
appreciated.
Thanx in advance
Ankur jain
________________________________
Here's a new way to find what you're looking for - Yahoo! Answers
<http://us.rd.yahoo.com/mail/in/yanswers/*http://in.answers.yahoo.com/>
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
