Hi Sarfaraz
Thanks for reply. Thats true but "who" is using these methods
(comm.sendRadioMessage() and comm.sendUARTMessage() ) to send messages to any
node. I assume its base station ie node 0.
Im looking forward to send messages from specific node. Lets say node 2 send
message to node 10. How we can do by using Tython.
Thanks in advance.
Looking Forward
Regards
Faisal Karim
----- Original Message ----
From: Sarfraz Nawaz <[EMAIL PROTECTED]>
To: Faisal Karim <[EMAIL PROTECTED]>
Cc: tinyos help <[email protected]>
Sent: Sunday, June 3, 2007 6:12:12 AM
Subject: Re: [Tinyos-help] sending packets via Tython
comm.sendRadioMessage() and comm.sendUARTMessage() are used to send a
packet to "any" node in the network on the uart and radio respectively.
On 6/1/07, Faisal Karim <[EMAIL PROTECTED]
> wrote:
Hi All
Im
looking forward to send packets from specific node in simulation via
Tython. In Tython manual it is described to send using moteIF(), but
what i understand this is to send some msg from base station ie some
serial port. To send to base station there is a method
comm.sendUARTMessage(), also there is comm.sendRadioMessage() which im
assuming to send msg from base station to specific node via radio as
this method do not describe which node is sending the message.
any comments and help will be highly appreciated
Regards
Faisal Karim
Get the Yahoo! toolbar and
be alerted to new email wherever you're surfing.
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
____________________________________________________________________________________
Take the Internet to Go: Yahoo!Go puts the Internet in your pocket: mail, news,
photos & more.
http://mobile.yahoo.com/go?refer=1GNXIC_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
