Hello Giri, I readed user's manual of MoteConfig for program the new firmware in nodes. By the moment i only can the firmware of gateway with the version of high power in folder mica (C:\Archivos de programa\Crossbow\MoteView\xmesh\mica2\433MHZ\XMeshBase). RF power 255, channel 00, in fuse setting external ocillator on option active and in address and radio defaults firmware scan.
Now i not get data of gateway of the other nodes in MoteView. Gateway appear disconnect. The last line in console is Hearbeat received..... I readed in manual: "*NOTE: **OTAP *is currently available only when *the*Motes are programmed with a high power firmware application( i.e. XMTS310CB_433_hp.exe*).**"* And in your before reply you said to me that nodes have a low power version, then i not can program the nodes. I think that for programming i must connect directly in serial port, but where connect the wire??? I wait that someone can help me. Thanks in advance. Best regards, Juan Antonio. 2007/6/19, Juan Antonio López Riquelme <[EMAIL PROTECTED]>:
Hello Giri, more thank for your reply. Best regards, Juan Antonio. 2007/6/18, Giri Baleri <[EMAIL PROTECTED]>: > > Hello Juan, > > The MEP nodes in the MEP-SYS are programmed with XMesh 1.2 firmware and > the low power version of this app doesn't support the commands (eg. > change data rates). You need to reprogram the MEP nodes with the newer > MEP application firmware available in MoteWorks to change the data rate etc. > > > Regards, > Giri Baleri > Crossbow Technology, Inc > > ------------------------------ > *From:* [EMAIL PROTECTED] [mailto: > [EMAIL PROTECTED] *On Behalf Of *Juan Antonio > López Riquelme > *Sent:* Monday, June 18, 2007 11:33 AM > *To:* tinyos-help > *Subject:* [Tinyos-help] Problems with Moteview 1.4 and MEP-SYS of > CrossbowInc. > > > Hi, > > I am using MEP-SYS and Moteview 1.4c from Crossbow Inc (http://www.xbow.com/Products/productdetails.aspx?sid=245). > I tried to change the LEDs status of only MEP410 nodes and the sample rate > in all nodes (MEP410 and MEP510) using the option command in tab control. > After this, I don't see any changes in the leds and data change with the > same sample rate that there was before changing in the option data of tab > control. > > Can anyone give any advice to solve this problem? > > PD. I received all nodes pre-programmed. > > thanks in advance > > greetings > Juan Antonio. >
_______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
