On Jul 9, 2007, at 9:50 PM, Andy Dalton wrote:
Greetings,
I'm looking to control the default radio power level at runtime for
Telos motes using TinyOS-2.x. In tos/chips/cc2420/CC2420Power.nc I
see the following comment:
"[This] does not include transmission power, see the CC2420Config
interface."
However, the CC2420Config interface does not include any command to
set the default radio power level. The file
tos/chips/cc2420/CC2420ControlP.nc includes a state variable
'm_tx_power' that is initialized to CC2420_DEF_RFPOWER; however, that
variable is never used. The file tos/chips/cc2420/CC2420TransmitP.nc
directly uses CC2420_DEF_RFPOWER to set the default power level:
if ( !tx_power ) {
// If our packet's tx_power wasn't configured to anything but 0,
// send it using the default RF power. This assumes the
// packet's metadata is all set to 0's on boot.
tx_power = CC2420_DEF_RFPOWER;
}
It looks to me like the original intent was to provide a software
interface for setting the default radio power level via the
CC2420Config, but that its realization got lost along the way. With
the current implementation, I cannot see a way to set the default
radio power in software.
One way to resolve this would be to add two new commands to the
CC2420Config interface:
command uint8_t getDefaultTxPower();
command void setDefaultTxPower(uint8_t txPower);
Then, in CC2420ControlP add implementations of those commands (again,
'm_tx_power' is already declared in this module and initialized to
CC2420_DEF_RFPOWER):
command uint8_t CC2420Config.getDefaultTxPower() {
return m_tx_power;
}
command uint8_t CC2420Config.setDefaultTxPower(uint8_t txPower) {
m_tx_power = txPower;
}
Then, in CC2420TransmitP use the CC2420Config interface, and call the
getDefaultTxPower command to set the default power:
if ( !tx_power ) {
// If our packet's tx_power wasn't configured to anything but 0,
// send it using the default RF power. This assumes the
// packet's metadata is all set to 0's on boot.
tx_power = call CC2420Config.getDefaultTxPower();
}
Does this seem reasonable? Am I missing some other mechanism to set
the default radio power level in software?
Thanks in advance for your assistance.
Looks like the comments are out of date with respect to the
implementation.
Based on experiences in implementing protocols, the general approach
TinyOS takes these days for things like TX power control,
acknowledgements, etc., is to make them per-packet. Otherwise
protocol A changes the radio settings, which causes protocol B to
break. If you take a look at CC2420Packet, there's a command to set
the TX power level of a given packet.
Phil
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
