The problem is with the digit to be put after "ttys0 " in
MIB510='/dev/ttys0' make mica2 install.0 mib510
By S0 you refer to the COM1 port which is a 9-pin serial port .
To get the correct port number do the following :
1. RIght-click on My Computer and click on Properties.
2. Go to hardware and then Device Manager.
3. The click on Ports .
Your USB to serial port number would be displayed here. If COM4 is displayed
try "S3" and then "S4" when you install the tinyOS code.
Also if you are gonna read any sensor readings from the serial port, set the
baud rate and other protocol options by "right-click " on the displayed port
number and selecting properties.
Hope this helps,
Aneeket.
---------------------------------
Building a website is a piece of cake.
Yahoo! Small Business gives you all the tools to get online._______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
