What was the state of the serial port on the usb connector? Are you using
printf?
----- Original Message -----
From: Kevin Klues
To: Roberto Vittorio
Cc: tinyos-help
Sent: Sunday, December 16, 2007 12:35 AM
Subject: Re: [Tinyos-help] CURRENT ABSORPTION ON THE EXPANSION CONNECTORS
ADCWITH TINYOS -2.x
This sounds discouraging. What was your test setup exactly?
Kevin
On Dec 14, 2007 7:56 AM, Roberto Vittorio <[EMAIL PROTECTED]> wrote:
Hello all, the question is: if I install on Telosb the BlinkC component or
any other program running on Tinyos-2.x, I see a current absorption on the
expansion connectors (channel ADC0, ADC1 ADC2 ADC3) about of 7-10 mA . Instead
if install the same component on Tinyos-1.x, the current equals 0 mA. What's
happening with Tinyos 2.x? I suspect that the ADC are sets in output or
something similar. Thanks in advance, Roberto
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
--
~Kevin
------------------------------------------------------------------------------
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
