It would help to know what TOS version you use and
to take a peek at the relevant code. When you try to switch ADC
channels do you get the same x-axis data, or something else?
And where do I get a cool 3-axis accel with 2-axis gyro sensor board?
MS
John Grimm wrote:
I have been working on a project with a telos rev A for the last couple
of months. I have run into a brick wall recently. We are trying to read
an external accelerometer and send the raw date. That's it. The problem
is that I can read and send the x-axis no problem but I cannot seem to
read all three axis plus the 2axis gyroscope and send the data. I am
using the TELOSADC as an example but as I said I am stuck on one
channel. I appreciate the help. I have been through the contributed code
and the archives but I can't quite seem to find what I am looking for.
**John A. Grimm
**
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.503 / Virus Database: 269.17.4/1189 - Release Date:
12/18/2007 9:40 PM
------------------------------------------------------------------------
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
--
Platform: WinXP/Cygwin
TinyOS version: 1.x, Boomerang
Programmer: MIB510
Device(s): Mica2, MicaZ, Tmote
Sensor board: homebrew
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
