Hi is there a way to hard-reset the MICAz fuses? I have a mote that may have been programmed with "bad" fuse settings, bricking it in the process. It won't program or respond to uisp fuse/erase/etc commands.
I have tried using an AVRICEmkII and AVRstudio to reset them (don't think I have a "squid cable" as called for in the last-ditch effort to prog. the mote by AVRStudio if that's important or can even be used with micaz?) but I fear that as the standard tos install setting disables jtag this is also not possible. Not quite sure how to proceed ... any help would be appreciated! There aren't like two pins to short to reset the lot manually are there? Cheers, Ben Firmware Version: 2.1 An error has occurred during the AVR initialization. * Target status: Vendor Code = 0xff, Part Family = 0xff, Part Number = 0xff Probably the wiring is incorrect or target might be `damaged'. ******************************************************************************* Please consider the environment before printing this email. ******************************************************************************* This email and any files transmitted with it are intended solely for the use of the individual or entity to whom they are addressed and may not be divulged to any third party without the express permission of the originator. Any views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of Thales Research & Technology (UK) Limited. ******************************************************************************* _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
