Hi Has anyone here any experience with using "high-voltage programming" to rescue a mote. Preferrably a mica/2/z mote?
I managed to set the fuses on a MICAz such that the mote is not responding to either JTAG nor (u)ISP commands. I have contacted atmel who said that I could recover the atmega128 chip through the use of "high-voltage programming". I've scanned over the relevant atmel datasheets but am unsure as to how the conections should be made between the programming device and the mote/programmig board (for e.g. where/how do I access the "reset" pin on the micaz through which this HV programming supposedly occurs? It all sounds a little daunting - I have been told to call over the others in the office so if it goes up in smoke there's an audience to enjoy it :) I have available to me so far: AVR ICE mkII jtag emulator pod AVR stk500 development board Many Thanks! Ben ******************************************************************************* Please consider the environment before printing this email. ******************************************************************************* This email and any files transmitted with it are intended solely for the use of the individual or entity to whom they are addressed and may not be divulged to any third party without the express permission of the originator. Any views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of Thales Research & Technology (UK) Limited. ******************************************************************************* _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
