The mib520 uses the same protocol as the mib510, hence you'll need to use make micaz install mib510,com4
Janos -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Javier Zazo Sent: Thursday, March 06, 2008 6:24 PM To: [email protected] Subject: [Tinyos-help] Error programming micaz using mib520: Direct ParallelAccess not defined Hi, I use tinyos-1.1.15 and I have a mib520 board. I can compile Blink application for example, but cannot burn it in micaz. This is the command I have tried, and many others with the same result, for example, changing com4 for /dev/com4 (this is my virtual serial port) make micaz install mib520,com4 This the error I receive after compilation: (...) uisp -dprog=mib520 -dserial=/dev/com4 --wr_fuse_h=0xd8 -dpart=ATmega128 --wr_fuse_e=ff --erase --upload if=build/micaz/main.srec.out Direct Parallel Access not defined. make: *** [program] Error 2 I have tried lots of command combinations and changing the permissions do not work I have seen other posts similar to this one, stating in the end that the problem is with uisp and tinyos not giving support to mib520 (I get same error if I use mib510 word instead) I have looked through all forums and found no answer for this problem, at least for windows. In other systems as SOS, they recommend a patch of uisp for these boards, and I have tried them and got errors when burning the motes. Only this way have I been able to burn Blink once, but with a lot of errors in the output window. I do not know if someone has already gone through this, and had found a solution. Thanks for your help. Javier Zazo _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
