Hi,
I'm new here. I hope somebody could help me.
I like to use USART1 at the IRIS mote under TinyOS-2.x to receive raw data for
example from GPS-device at MTS420 sensor board.
Because SerialActiveMessage use UART0 I wrote my own configuration to connect
HplAtm128UartC.Uart1 like at Atm128Uart0C with SerialP to get an UartStream.
At time the UartStream.receive execute, but unfortunately with byte equal 0x00.
I'm not sure where could be my failure, in code, baudrate or anywhere else. The
GPS-device communicat with 9600 baud.
I use
"make iris install baud,9600 mib510,/dev/ttyUSB0"
Thanks a lot,
Miles
configuration Atm128Uart1C {
provides interface StdControl;
provides interface UartByte;
provides interface UartStream;
uses interface Counter<TMicro, uint32_t>;
}
implementation
{
components new Atm128UartP() as UartP;
StdControl = UartP;
UartByte = UartP;
UartStream = UartP;
UartP.Counter = Counter;
components HplAtm128UartC as HplUartC;
UartP.HplUartTxControl -> HplUartC.Uart1TxControl;
UartP.HplUartRxControl -> HplUartC.Uart1RxControl;
UartP.HplUart -> HplUartC.HplUart1;
components MainC;
MainC.SoftwareInit -> UartP;
}
--
Der GMX SmartSurfer hilft bis zu 70% Ihrer Onlinekosten zu sparen!
Ideal für Modem und ISDN: http://www.gmx.net/de/go/smartsurfer
--
Psssst! Schon vom neuen GMX MultiMessenger gehört?
Der kann`s mit allen: http://www.gmx.net/de/go/multimessenger
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
