Check to see that the power switch on the mote and the on/off switch on the end of the MIB510 are both off.
Second, motelist only works with telosb. Very unfortunate. Eric On Mon, Apr 14, 2008 at 10:25 AM, <[EMAIL PROTECTED]> wrote: > (Firstly, I am resending this e-mail, because I have sent it previously > without being subscribed to the help mailing group, I do apologise if this > was received twice) > > When I try to > execute the make mica2 install command (with the right parameters, I am > sure about this), I get this error message: > 'Programmer is not responding. > make: ** [program] Erro 2' > I am using a MIB510 programming board, and it is correctly connected to > the computer. When I give this command, its red led starts to blink, but > nothing happens apart from that. ... > I type in "motelist", a message returns saying that there were no devices > found. > > Hoping to read from you soon, > Fernando. > _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
