AFAIK there is no easy-gui for this.
You may use MIG to generate a message class, or write your own,
which parses and prints in any format. That class can be plugged
in to Listen where the Dump class is currently. For a roll-your-own
solution see my code bolus:
http://www.etantdonnes.com/Motes/robocode.tar.gz
MS
Maria Taramigkou wrote:
> Hello!
>
> I'm using tinyos-1.1.15, telosb motes and I would like to know if
> there's any way to display sensor data in a refined mode,as follows:
> group id,seq-num,voltage,temperature etc.How could I translate raw
> data(bytes) into recognizable
> measurements?Is there any tinyos gui-tool on tinyos for telosb motes?
>
> Thank you very much!
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
--
Platform: WinXP/Cygwin
TinyOS version: 1.x, Boomerang
Programmer: MIB510
Device(s): Mica2, MicaZ, Tmote
Sensor board: homebrew
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
