Xbow has some support in TOS 1.x in:
tinyos*/contrib/xbow/tos/sensorboards/mda300
I don't know if it got to T2 though.
MS
Steve Yazicioglu wrote:
> I'm rather new to TinyOS, so my question may seem rather elementary.
>
> I am trying to use the channels D0-D5 on the MDA300CA DAQ board, fitted
> with a MICA2, as outputs to control some external switches for powering
> some sensors on and off. I haven't been able to find any documentation
> or examples on this. Basically, I just need some help on how to access
> these pins in my .nc files, how to set them to output, and how to
> control them. Any response would be greatly appreciated!
>
> -Steve
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
--
Platform: WinXP/Cygwin
TinyOS version: 1.x, Boomerang
Programmer: MIB510
Device(s): Mica2, MicaZ, Tmote
Sensor board: homebrew
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
