Hi, I want to connect my micaz motes to the computer's usb port without using the programming board(MIB510) because I have many motes but only 1 programming board(cant afford more! ). With ony one programming board, I'm unable to debug the program running in all the motes simultaneously
USB male to female connector-cables are available in abundance. I figured out that a USB connector has 4 pins. And the prototyping area of my mda100cb sensor board has 3 pins labelled UART1_RX UART1_TX UART1_CX So should I solder these 3 pins and ground to the 4 pins of USB female side of the cable? (in which order?) Can I connect many motes in this way to multiple USB ports of the same computer? Will the debuggging messages sent using printf from all motes be displayed? Thanks in advance Regards, Abhishek Anand IIT Guwahati alt email: [EMAIL PROTECTED] http://abhishek.anand.iitg.googlepages.com/home
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
