Hi Min, That's the only difference i found as well between mode 2 and normal buffered mode which is referred as 0 in the register.
My experience doing PER/BER measurements is that i didn't find how to do change receive mode in Tinyos. So i finally did it with the Ember Rangetest firmware and two EM2420 radio chips. This firmware will give you directly the PER. Hope this helps, ------- Rodolfo -----Original Message----- From: Min Guo [mailto:[EMAIL PROTECTED] Sent: Wed 11/06/2008 11:41 AM To: rodolfo de paz Cc: [email protected] Subject: Re: [Tinyos-help] PER/BER measurements Actually, I also want to ask a related question, is the the following the ONLY difference between mode 2 and mode 1: with mode 2: there is no validity checking for the received information, the receiver simply put any received message into the RXFIFO buffer in a cyclic way. And The buffer overflow is ignored. On Wed, May 7, 2008 at 3:57 PM, rodolfo de paz <[EMAIL PROTECTED]> wrote: > Hi all, > > I would need to do BER/PER measurements using 2 micaz motes. In cc2420 says > that this could be done using test mode 2 but it doesn't say specifically > how to do that, anyone knows more about this? > > Thanks for any help, > > Rodolfo. > > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help >
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
