I mean that the radio is unable to transmit any packets while the PhotoC component is wired into the configuration. When I unwire the PhotoC component, the radio starts working perfectly.
Tahir. On 7/8/08, Philip Levis <[EMAIL PROTECTED]> wrote: > > On Jul 7, 2008, at 12:45 PM, Tahir Azim wrote: > >> Hi, >> >> I am trying to get the light sensor of an MTS300 sensorboard (I >> think its CB as it has the green wire at the back) to work with a >> micaZ mote. I started from the tinyos 2.0.0 release code, but >> couldnt get it to work. So I copied over the tos/sensorboards/mts300/ >> * files from the tinyos 2.0.2 release and then made the following >> changes: >> >> * Changed MicaBusC.nc by adding the Int0,1,2,3 pins and wiring them >> to HplAtm128GeneralIOC.PortE4,5,6,7 respectively. >> * Replaced ResourceDefaultOwner with ResourceController in >> PhotoTempDeviceC.nc >> >> This enabled me to compile the code and get it running on the micaz >> with the PhotoC sensor wired into my app. But simply wiring in the >> PhotoC sensor (and not even calling 'read' on it) causes the radio >> to stop working. I've also tried changing >> >> TempControl.Power -> MicaBusC.Int2; >> >> in PhotoTempDeviceC.nc to >> >> TempControl.Power -> MicaBusC.PW0 >> >> as per a previous email on this list, but that doesnt enable the >> radio to work either. >> >> Is there some way I can still get the light sensor and the radio to >> work in this configuration? Or must I update my entire tinyos tree >> to 2.0.2? > > Can you define "causes the radio to stop working?" > > Phil > _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
