I am using micaz with mib520 as the processing board and tried the Blink
example on it. But the red LED does not blink after the Blink program
is installed on the micaz.
Here is the command I used to compile and install the Blink program and
the output I got.
-------------------------------------------------------------
$ make micaz reinstall mib520,com3
cp build/micaz/main.srec build/micaz/main.srec.out
installing micaz binary using mib520
uisp -dprog=mib520 -dserial=com3 --wr_fuse_h=0xd9 -dpart=ATmega128
--wr_fuse_e=f
f --erase --upload if=build/micaz/main.srec.out
Firmware Version: 1.8
Atmel AVR ATmega1281 is found.
Fuse High Byte set to 0xd9
Fuse Extended Byte set to 0xff
Uploading: flash
rm -f build/micaz/main.exe.out build/micaz/main.srec.out
-----------------------------------------------------------------
I don't see verification of flash step in the output but there is no
error message either. Does that mean the program has been successfully
uploaded? I did see red led flashed during the upload.
When I type "rpm -qa" in cygwin window, it shows "tinyos-tools-1.2.3-1".
Does that mean I am using version 1.2 of tinyos? Do I need a higher
version of tinyos to work with micaz?
Another thing I noticed is that before I download the Blink program to
micaz, the red, green and yellow leds flash everytime I power it on with
usb power. But after Blink is installed, no leds flash when I switch the
power.
Anybody had seen similar issues before? Any suggestion is appreciated.
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
