Hi Tony, To enable brown-out detection you have to program the corresponding fuse. The following document explains how to program fuses (look especially at the last two pages):
http://www.xbow.com/Support/Support_pdf_files/UISPHELP.pdf In essence, you should probably read the current fuse settings, change this value by setting the bit corresponding to the BODEN fuse to 1, and then write the fuses back to the mote (optionally, read the fuse settings again to make sure your changes were written correctly). Cheers, Urs Razvan Musaloiu-E. wrote: > Hi! > > On Thu, 22 Jan 2009, Tony Han wrote: > >> Thank you for the help, Urs, >> >> I am not sure if the problem is due to brown-out. Since without >> re-install >> the program, that mote cannot function properly again. However, I will >> try >> your suggestion to see if brown-out detection will help to prevent this >> happen. >> >> I never heard about brown-out detection on mote, could you specify >> where and >> which datasheet I should looking for? >> > > Page 53 from here is probably a good place to start: > http://www.atmel.com/dyn/resources/prod_documents/doc2467.pdf > > All the best! > Razvan ME _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
