Hi Tommaso, Thank you for your information. Sure it is helpful. I'm using application on Mote from Xmesh series. The base program is also from the same place.
I have no clue now what could be the issue. Can you please provide me with some more info on this..your help is highly appreciated. Thanks, Sravan. On Wed, Oct 28, 2009 at 1:26 PM, Tommaso <[email protected]> wrote: > Hi! > > I had the same problem: if you install on a mote(with mib520)a program in > the XMESH serie, then, when you prepare the node, it run! > The solution is in the differences between your app's configuration file > and the XMESH app's configuration file, in particular for the wiring of > MULTIHOPROUTER... > At the moment I don't remember what change I've done, but the problem is > there. > > I hope I was helpfull... > > Regards, > > Tommaso Sorrentino > > > Sravan Kumar Thokala ha scritto: > >> Hi Gentlemen, >> >> I need your help in remotely programming the Motes. >> I would like to remotely program micaz program using MIB520 base and >> Moteconfig. In the Moteconfig the application kinda of stuck when starting >> to prepare... >> >> The following message showed up... >> >> Xserve:Connected to XServe! >> xotap.exe -sf localhost:9001 -i 0 -p 7 >> Node preparation may take up to 1 minute... >> >> The message said node prep may take upto 1 min.. but it never came out of >> this... >> >> Can you please help me if there is any work around for this problem. I >> really need to program these motes remotely. Any help is appreciated. >> >> Regards, >> Sravan. >> >> ------------------------------------------------------------------------ >> >> _______________________________________________ >> Tinyos-help mailing list >> [email protected] >> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help >> > >
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
