Hey, I am using telosb and tinyos-2.x.
I want to run my application code several times. So I need to reboot the remote motes with the same image more than once. These are the steps that I am following. 1.install Goldenimage- with light basestation enabled, to all the remote motes.I am also giving the ids here. 2.install Goldenimage- with basestation enabled to BS. 3.enable CFLAGS += -DDELUGE_LIGHT_BASESTATION to Makefile of deluge/Blink,compile and inject to BS as image 2. 4.use d2 to disseminate this image to remote motes. 5.enable CFLAGS += -DDELUGE_BASESTATION to Makefile of deluge/Blink,compile and inject to BS as image 2. 6.repeat steps 3,4,5 for my application code. 7.dr1 to reboot remote motes. 8.r1 to reboot BS. 9.my code is executed. Now I want to reboot all the motes with the same image. I tried doing this by going to image 2 and then coming back or just use dr1 and r1 again. But it doesnt work for the remote motes. > Hi! > > On Thu, 10 Dec 2009, deeksha g rao sahib wrote: > >> Hi, >> >> I am not able to switch between the 2 images in the flash using the >> commands dr1,r1,dr2,r2. they seem to work only the first time reboot >> commands are used when they have Goldenimage in the current working >> directory. >> >> in the sample blink program, once the base station and remote motes >> start >> blinking, i want to switch to my application program which is in image >> 2.Now the dr1 command is being sent but the remote motes would not >> reboot. >> >> I have taken care of the CFlags for Base station and remote motes while >> injecting and disseminating the images after giving node ids using >> goldenimage. >> >> can somebody please help me with this??? >> > > Can you please indicate the platform you are using, what version of tinyos > are you using and what are the exact steps you are doing? > > Switching the images should work properly. For example the following test > should work: > > - install deluge/Basestation on mote BS > - compile deluge/GoldenImage and inject in volume 1 on BS > - compile deluge/Blink and inject in volume 2 on BS > - install deluge/GoldenImage on mote M > - disseminate+reboot (-dr) image 2: M should get and start running > deluge/Blink. > - disseminate+reboot (-dr) image 1: M should get and start running > deluge/GoldenImage. > > After these steps M has volume 1 and volume 2 populated so you could > disseminate+reboot 1 and 2 without the images being transfered. > > Note: I highly recommend using the latest CVS. :-) > > -- > Razvan ME > > -- > This message has been scanned for viruses and > dangerous content by MailScanner, and is > believed to be clean. > > > -- > This message has been scanned for viruses and > dangerous content by MailScanner, and is > believed to be clean. > regards, deeksha -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
