Hi everyone: Hope to gain some warm responses from you ! I have a question about viewing the out viewing the output from the mote(s). I am going through some of the tutorials that come with the software package and I am currently on lesson 2(for those of you who have gone through the tutorials as well these tutorials are in the MoteWorks Getting Started Guide section 6.2.4 or page 53-54. I was successfully able to compile and install the code on the mote with no problems. In this tutorial the micaz and MDA100 sensor board are both connected to the a MIB510 programming board on opposite sides. But here always appears the following output:
$Xserve -mib510=com3 xdebug: could not open log file /opt/MoteWorks/tools/xserve/bin/logs/xserve_log.txt: No such file or directory XSERVE 2.0.E: $Id: xserve.c,v 1.8.2.3 2007/02/02 17:45:01 rkapur Exp $Using params: [raw] [ parsed] [converted] [server port=9001] Opening serial device: /dev/ttyS0 @ 57600;Then there is no output to the screen the cursor continues to blink and stare me in the face. From the screen shots in the user's manual/guide there should be output scrolling along the screen, but for some reason there isn't. So I want to ask some questions based on the above output. If anyone can provide me with some insights I would greatly appreciate it. Looking forwark for your help and reply!!Thank you very much! Best Regards;
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
