Hi dear Harald, thanks for your answer. you mean with using AMControl.Stop() ?, in this case how is the energy consumption in comparison to when AMControl is started ?
You know,actually i want to know the difference from point to point sending and broadcast sending in sensors. When we use AMSend.send(node address,...).Only The mentioned node will receive the message, not any other node(even if we turned on the AMControl for every node in the network in advance),but when we use the AMSend.(broadcast addr,...) every neighboring node in the network that turned the AMControl on, will receive the message. So in the case AMSend.send(node address), how the Radio send the message to this specific node ? Any help would highly appreciated. On Fri, Sep 10, 2010 at 12:11 PM, Harald Sauff <[email protected]>wrote: > > How can we neglect a message from being received(for energy efficiency) ? > > Switch off the radio. > Problem: If there is a message that you want to receive, you have to > know in advance and switch the radio on before the message arrives. > > > greetings, > Harry > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > -- Mojtaba Raznahan BS of Computer engineering TMU university www.raznahan.com
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
