Or use an Alarm (async) or you can run the ADC module in streaming mode. Miklos
On Sun, Sep 26, 2010 at 7:06 PM, Michael Schippling <[email protected]> wrote: > Prior to TOS1.1.10 one could use a Timer() interval of 1, > but at that version a lower limit of 3 was instilled -- > I think to avoid some kind of timing problem with micaz's. > The limit was enforced by having start() return an error > rather than just upping the ante and returning as it seems > to be doing in your case. > > You could roll back to TOS1.1.7...hah hah, a little joke... > or look into other timer implementations in T2, or even > poke into the Timer code and remove the limit just to > see what happens. > > MS > > Elham Dolatabadi wrote: >> >> >> Hello, >> >> For my application, I use iris mote and mda100cb sensor board. I am also >> working with tinyos-2.1.0. As you know the default sampling interval in >> oscilloscope application is 256 ms. When I changed it to 5 ms, all >> results were acceptable. However, I need sampling rate of 1 kHz which is >> 1 ms interval. By changing the interval to 1 ms the results were as the >> same as 5 ms. It seems that it didn't work. Can any one help me solving >> this issue and getting 1 KHz sampling rate?????????? >> >> E.D >> >> >> ------------------------------------------------------------------------ >> >> _______________________________________________ >> Tinyos-help mailing list >> [email protected] >> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
