Here's my list of mica pinouts:
http://www.etantdonnes.com/Motes/ATMEGApins.txt
Pretty much any I/O pin that is not labeled as used
by the controller board is available to you. The PW,
or PortC, pins are most commonly used for this.
The way of reading an I/O pin changed between T1 and T2,
so I would look in the tutorial, doc, and code for samples.
There is a component like GeneralIO in T2 I think.
MS
sumit bhogal wrote:
> Can anybody tell me what is the procedure to interface PIR sensor with
> crossbow micaz mote and its programming board. Which pins should i use
> from 51 pin interface slot to get output. What changes should i made in
> the already present codes in Tinyos examples to get my result??
>
> With regards
>
> Sumit
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
