Sir
I am using TinyOS 2.x. I am getting errors everytime i write following
command in the console after setting up the equipments,
*sensor@sensor-desktop:/opt/tinyos-2.x/apps/Blink$ make mica2 install
mib510./dev/ttyS0
mkdir -p build/mica2
compiling BlinkAppC to a mica2 binary
ncc -o build/mica2/main.exe -Os -finline-limit=100000 -Wall -Wshadow
-Wnesc-all -target=mica2 -fnesc-cfile=build/mica2/app.c -board=micasb
-DIDENT_PROGRAM_NAME=\"BlinkAppC\" -DIDENT_USER_ID=\"sensor\"
-DIDENT_HOSTNAME=\"sensor-desktop\" -DIDENT_USER_HASH=0x7212be51L
-DIDENT_UNIX_TIME=0x4db19962L -DIDENT_UID_HASH=0xbd34574bL
-fnesc-dump=wiring -fnesc-dump='interfaces(!abstract())'
-fnesc-dump='referenced(interfacedefs, components)'
-fnesc-dumpfile=build/mica2/wiring-check.xml BlinkAppC.nc -lm
compiled BlinkAppC to build/mica2/main.exe
2358 bytes in ROM
52 bytes in RAM
avr-objcopy --output-target=srec build/mica2/main.exe build/mica2/main.srec
avr-objcopy --output-target=ihex build/mica2/main.exe build/mica2/main.ihex
writing TOS image
cp build/mica2/main.srec build/mica2/main.srec.out
installing mica2 binary using mib510
uisp -dprog=mib510 -dserial=/dev/ttyS0 --wr_fuse_h=0xd9 -dpart=ATmega128
--wr_fuse_e=ff --erase --upload if=build/mica2/main.srec.out
**Firmware Version: 2.1
Probably the AVR MCU is not in the RESET state.
Check it out and run me again.
make: *** [program] Error 2
*
Please help!!!!
with regards
Sumit*
*
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
