I was thinking of directly writing assembly code to do the same. I have a basic question. How do i install the hex files generated after compiling the asm code. Can i use `telosb reinstall` for this? So that the newly generated hex file is installed on the mote.
Excuse if that sounds stupid. > Could this help? - http://www.sparkfun.com/products/9544 > > Regards, > > André > > ----- Original Message ----- > From: Eric Decker > To: Prasanna Karthik V > Cc: [email protected] > Sent: Saturday, May 14, 2011 8:00 PM > Subject: Re: [Tinyos-help] Spi Testing > > > > > In short, probably not. While SPI is a serial bus, most > implementations, especially the msp430 implementation enforces byte > boundaries. The smallest unit of transmission is a byte. > > > On Sat, May 14, 2011 at 11:28 AM, Prasanna Karthik V > <[email protected]> wrote: > > I am testing the SPI functionality of a connected radio. I could > see > that there are functions that send/read a byte over the SPI to/from > the radio. > > Is there any lower level interface that enables us to send a > bit(through > SI) over the SPI , thereby receiving the same bit on SO pin? > > In short, i want to do bit-banging and test the SPI device's working > status. > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > > > > > -- > Eric B. Decker > Senior (over 50 :-) Researcher > > > > > > ------------------------------------------------------------------------------ > > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
