Hello everyone,
I'm using IRIS, mib510 with Tinyos2.x. I want to using UART0 to read a
sensor. I try to use component HplAtm128UartC. How can I change the baud rate
on UART0?
If I cannot use the component, do I need to use interface UartStream? In
this interface, can I change the m_byte_time=3200 to set the baud rate to 1200?
Any help will be appreciated.
Haixia Li
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
