Hallo,
unfortunately I wasn’t successfully in reading out the i2c_status..
I successfully included the dbgmsg-components but on the pc-side
I can’t receive dbg-messages.
(I use blip‘s ipbasestation ..does it work together?)
If you want to reconstruct the i2c error you can manually pull
scl low for a long (ca. 2-3 sec) time, while you are reading out
an i2c sensor with a cycle time of 1 sec…
I think that will end in the same error state which occurs in
communication with the co2 sensor I’m using..
I think it doesn’t make sense for me to go one trying to find
out where the problem in the communication between co2-sensor and
i2c-device driver is, because I don’t really overlook the i2c-device
driver..so first of all I think I should do the bit-banging workaround…
Best regards
Sebastian
--
Empfehlen Sie GMX DSL Ihren Freunden und Bekannten und wir
belohnen Sie mit bis zu 50,- Euro! https://freundschaftswerbung.gmx.de
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
