Hello,
While I was trying to run the simulation for power tossim I have got the
following problems:
1. When I use the command "python postprocessZ.py -h=led application.trace
" I got this error :
Efficiency table loaded, size=102
Recovery table loaded, size=11
Traceback (most recent call last):
File "postprocessZ.py", line 766, in <module>
handle_event(l)
File "postprocessZ.py", line 694, in handle_event
event_handler[event[1]](mote,time,event[2:])
File "postprocessZ.py", line 505, in led_state_handler
assert ledstate=="ON"
AssertionError
2. Also, the trace file is very different from the example you have in
application
DEBUG (1): 56,LED_STATE,LED0,OFF
DEBUG (1): 56,LED_STATE,LED1,OFF
DEBUG (1): 0,LED_STATE,LED2,OFF
DEBUG (0): 105,LED_STATE,LED0,OFF
DEBUG (0): 105,LED_STATE,LED1,OFF
DEBUG (0): 0,LED_STATE,LED2,OFF
The simulator displays the seconds and not the time simulation ticks. The
debug statments I have used is :
dbg ("energycheck","%hhu,LED_STATE,LED2,ON \n",sim_time());
dbg ("energycheck","%hhu,LED_STATE,LED2,OFF \n",sim_ticks_per_sec());
and both of them have the same output.
I would appreciate any help from your side. Also, it is possible to have the
nc code and the python script which you have used in order to generate the
trace file example "PowerTOSSIM2_RadioCountToLedsMote0Reversed"
Thanks,
John
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
