I'm going to assume that you mean "receiving an analog signal"...
Look at the code for the light or temp modules. It will take a little digging but you should be able to get down to the raw ADC level. Then copy it, probably all you need to do is change the ADC channel used. MS Hasib1 wrote: > Dear all, > > I want to configure a ADC channel for sending analog signal. My temperature > and light sensor is working. now i want to connect an analog signal of > voltage level 0-3 V to any one of the ADC port provided in MDA100. I am > using MIB520 as Base station. If any one can help e in configuring that i > would be really really grateful. > > I have not used this before so ay help would be of great value. > > Regards, > > Hasib _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
