Thanks, and again gone through the manual found the line "press reset button".
Thanks, Ramana. One more doubt is, on order to output continuously On Thu, Aug 30, 2012 at 2:41 PM, Tilemachos Papatheodorou < [email protected]> wrote: > Hi Ramana, > > just press the reset button. If you still have problems use the "motelist" > command to check if your telosb is on USB0. > > regards, > > Tilemachos > ------------------------------ > Date: Thu, 30 Aug 2012 14:33:21 +0530 > From: [email protected] > To: [email protected] > Subject: [Tinyos-help] Using the TinyOS printf Library > > > Hi Everyone, > > I have tried with printf library in tinyos, but could not get any output > on the terminal. > > Done the following steps on telosb mote in *tinyos-2.1.1/apps/tutorials/Printf > *directory. > > $make telosb install.0 bsl,/dev/ttyUSB0 > After properly installed on the telosb mote > I run the following command. > > $java net.tinyos.tools.PrintfClient -comm serial@/dev/ttyUSB0:telosb > > But I did not get any output, it simply waiting. > > *The output is:* > Thread[Thread-1,5,main]serial@/dev/ttyUSB0:115200:resynchronizing > > What is the problem in that. Help in this regard is highly appreciated. > > Thanks, > Ramana. > > _______________________________________________ Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help >
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
