Hi all, I hope that you could help or advice me on this.
I have an app which uses the Msp430Adc12ClientAutoDMAC as the ADC client(I am using TelosB). I take ADC samples for a second, release the resource, wait for 30 seconds, and then repeat the process all over again. All works fine except that my measurements indicate that the mote consistently draws .5 mA, even during the 30 second interval. Is there a way to further minimize this? In another experiment that I ran(there is no DMA component in the app used), when the radio is turned off between sends, the current draw drops all the way down to 0.1mA(or lower, the datalogger already says 0). Can the same level of current draw be achieved when using the ADC? Much thanks.
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
