Hey Eric, Thanks, it was mislabelled. Figured it out now
On Fri, Sep 20, 2013 at 8:24 PM, Eric Decker <[email protected]> wrote: > > > > On Fri, Sep 20, 2013 at 2:47 AM, Andres Mabini > <[email protected]>wrote: > >> Hi everyone, >> >> I'm not sure whether this is the right place to ask this as this is more >> of a TelosB issue than a TinyOS one, but I'd give it a try any way. >> >> I've been trying to use the UART port of the TelosB(I am using TinyOS) to >> communicate with another device. I haven't had much luck with that however, >> so to help with debugging I got a USB-UART converter and used cutecom. The >> cutecom tells me that the TelosB is giving out the character stream that I >> wanted it to give, and at the right intervals as well. "Problem" is, it >> only works when I connect RX to RX and TX to TX. All of the materials that >> I've read so far says that it should be RX to TX. >> > > Physically the h/w works RX <- TX and TX -> RX. > > So there is something happening in the cabling. Not sure what is going > on but physically it has to be RX to TX. So something somewhere is > getting swapped. > > > >> >> Even in the other device, I only get some results(though erroneous) when >> the connection is RX-RX/TX-TX. >> >> Any ideas? >> >> >> >> _______________________________________________ >> Tinyos-help mailing list >> [email protected] >> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help >> > > > > -- > Eric B. Decker > Senior (over 50 :-) Researcher > >
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
