Hi, everybody
I'm new to TinyOS and trying to write the simple Blink application into sensor
mib510. But I didn't succeed yet since there is always an error: Permission
denied.
I have already tried the command:
$ sudo chown qingbi:qingbi -R /opt/tinyos-2.1.2/
And it still doesn't work.
By the way, the make micaz sim part could work well in my PC.
The running result is attached below, hoping someone could help me out. Thank
you so much.
qingbi@qingbi-VirtualBox:~$ cd tinyos-2.1.2/apps/Blink/
qingbi@qingbi-VirtualBox:~/tinyos-2.1.2/apps/Blink$ make micaz install
mib510,/dev/ttyUSB0
mkdir -p build/micaz
compiling BlinkAppC to a micaz binary
ncc -o build/micaz/main.exe -Os -fnesc-separator=__ -Wall -Wshadow -Wnesc-all
-target=micaz -fnesc-cfile=build/micaz/app.c -board=micasb
-DDEFINED_TOS_AM_GROUP=0x22 --param max-inline-insns-single=100000
-DIDENT_APPNAME=\"BlinkAppC\" -DIDENT_USERNAME=\"qingbi\"
-DIDENT_HOSTNAME=\"qingbi-VirtualB\" -DIDENT_USERHASH=0xdca414e2L
-DIDENT_TIMESTAMP=0x53399425L -DIDENT_UIDHASH=0x1fc3b583L -fnesc-dump=wiring
-fnesc-dump='interfaces(!abstract())' -fnesc-dump='referenced(interfacedefs,
components)' -fnesc-dumpfile=build/micaz/wiring-check.xml BlinkAppC.nc -lm
compiled BlinkAppC to build/micaz/main.exe
2044 bytes in ROM
51 bytes in RAM
avr-objcopy --output-target=srec build/micaz/main.exe build/micaz/main.srec
avr-objcopy --output-target=ihex build/micaz/main.exe build/micaz/main.ihex
writing TOS image
cp build/micaz/main.srec build/micaz/main.srec.out
installing micaz binary using mib510
uisp -dprog=mib510 -dserial=/dev/ttyUSB0 --wr_fuse_h=0xd9 -dpart=ATmega128
--wr_fuse_e=ff --erase --upload if=build/micaz/main.srec.out --verify
Error: Permission denied
-> /dev/ttyUSB0
make: *** [program] Error 1
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
